Work Instruction Of Garment Cutting Section
Garment cutting section is the most important section in garment industries. In this section fabrics are cut according to the marker dimension. There are two types of fabric cutting method. One is manual and another one is computerized. Cut fabrics are sorted according to the sizes and then numbered. Numbering is done to avoid shade variation of the fabrics. So, during numbering extra care must be taken.
Bond knife is used to cut smaller part of garments. Straight knife is mostly used in garment industries, by straight knife long parts and curve portion of garments can be cut.
As the garment cutting section plays an important role, the workers and engineers should maintain some work instructions for better output.
Work instructions:
- Before bring the fabric in cutting section the fabric is matched with approved fabric by the buyer (Generally GSM and Shade variation is measured).
- If the color, shrinkage, spirality, fabric dia, width, GSM is matched 100% then the fabric is received in storage.
- Then the fabric is inspected by 4 point system and the defects are recorded.
- OK fabric should be kept in relaxation at 24-72 hour.
- Then the fabric is laid in the table very carefully without looseness or tension free.
- Fabric lay height must be in the range of 2.5 – 3 inch and the length is between 7 yds.
- The black and white fabric cannot be laid in on the table.
- Before cutting the fabric the marker and pattern must be checked.
- In pattern length, chest, waist, bottom, sleeve length, sleeve open and its style must be checked and the operator must wear the metal hand gloves.
- After cutting, the cut panel must be bundled and for checking, it should be taken to the quality table.
- 100% record must be collected.
